7. Operation
WIKA Operating Instruction High Pressure Controller, Model CPC8000-H
33
GB
1
42
3
59
9
3
.0
0/
0
6/2
0
17
/GB
If the resolution of the instrument were set to 4 then the right most digit in the Digital Step screen
would correspond to the least significant digit of the setpoint and the left two digits in the Digital Step
screen would not be used.
Program Data Entry
The Program Data entry method provides an automated way to interact with the CPC8000-H. Many
setting or process that can be entered manually programmed into the unit and saved and used in the
Program portion of the data entry screen. Programs are prepared and stored in the Setup [
] /
[Application] / [Program] screen. See Section 7.3.5.3 Programs for details on how to create, edit and
save programs.
Figure 7-6 Program Data Entry Screen
After a program has been chosen by pressing the program selection button, press the Play [
]
button to start the program. The Pause [
] button can be pressed at any time to stop the program
at the current step, then the Play [
] can be pressed to resume. To move forward or backwards in
the program press the Back [
] button or the Forward [
] button. The Stop [
] button will
stop the program and place the CPC8000-H in Measure mode.
7.2.8 Setup
Press Setup [
] in the sidebar to move out of the main screen and into the setup screens. Notice
the bottom row of six subject tabs and the arrow on the left end of the row (see Figure 7-7 Setup
Screen Tabs). Each tab will bring up a screen relevant to the subject in the tab title.
Figure 7-7 Setup Screen Tabs
After regaining the main screen, the last visited setup screen will return if Setup [
] is pressed
again. Operational information for the setup screens and their associated sidebars is contained in
Section 7.3 Setup.
Current
program
and
program
