7. Operation
48
WIKA Operating Instructions High Pressure Controller, Model CPC8000-H
GB
1
4
2
3
5
9
9
3
.0
0
/0
6
/2
0
1
7
/GB
Tank Pump
The parameter [Tank Pump], sets the number of flooding cycle the unit will try to fill the volume
between the tank and the DUT. The flooding happens when the instrument switches from vent to
control mode. During the flooding process the instrument will take the fluid from the tank and will push
it in the system.
Figure 7-38 Rate Setpoint
7.3.4 Remote Tab
The Setup [
] / [Remote] tab is used to choose the command set that will be used for remote
communication from an external computer, select the IEEE-488 address, configure Ethernet
communication settings and configure serial communications settings. The [Remote] screen has two
pages that can be accessed by pressing the page selection [
] button. Details about
the remote operation and command sets are given in Section 8, Remote Operation. Information about
the electrical communication connection hardware is given in Section 0,