5. Transport, packaging and storage
24
WIKA Operating Instructions High Pressure Controller, Model CPC8000-H
GB
1
4
2
3
5
9
9
3
.0
0
/0
6
/2
0
1
7
/GB
5. Transport, packaging and storage
5.1 Transport
Check the instrument for any damage that may have been caused by transport.
Obvious damage must be reported immediately.
5.2 Packaging
Do not remove packaging until just before mounting.
Keep the packaging as it will provide optimum protection during transport (e.g. change in installation
site, sending for repair).
5.3 Storage
Permissible conditions at the place of storage:
Storage temperature: 0 ... 70 °C
Humidity: 35 ... 85 % relative humidity (no condensation)
Avoidance of exposure to the following factors:
Direct sunlight or proximity to hot objects
Mechanical vibration, mechanical shock (putting it down hard)
Soot, vapor, dust and corrosive gases
Potentially explosive environments, flammable atmospheres
Store the CPC8000-H in its original packaging in a location that fulfills the conditions listed above. If
the original packaging is not available, package and store the CPC8000-H as described below:
1. Wrap the instrument in an antistatic plastic film.
2. Place the CPC8000-H, along with shock-absorbent material, in the packaging.
3. If stored for a prolonged period of time (more than 30 days), place a bag, containing a desiccant,
inside the packaging.
WARNING!
Before storing the instrument (following operation), remove any residual media. This is of
particular importance if the medium is hazardous to health, e.g. caustic, toxic,
carcinogenic, radioactive, etc.
