All information, illustrations and technical specifications in these operating instructions are based on the latest information available at the time of
publication. We reserve the right to make design changes at any time without prior notification.
91
8.0 Maintenance
8.10. Maintaining and cleaning the precise overseeding unit
8.10.3. Rotary feeder shaft
Advice
Different spreading material may require special rotary feeders. For changing, it is recommended that
you keep pre-assembled shafts available according to the size of the rotary feeders, and always
exchange the entire shaft.
Removing the rotary feeder shaft
1.
Press pressure piece
(1)
of the shaft, turn to
the right and remove.
2.
Pull out shaft
(2).
If not possible, please use
the sup- plied tool
Cleaning rotary feeders
•
Pull the rotary feeders off the shaft and clean them. Check individual parts for
damage and wear, renew if necessary.
•
When dismantling the shaft, identify the sequence of components, and push back
onto the shaft in reverse order when assembling. During assembly, make sure that
the rotary feeders are mounted offset in relation to one an- other..
•
Rotary feeder shaft structure, see:
8.10.7. "Spare parts for rotary feeder shaft blue, 1 x 5,0 ccm"
8.10.8. "
Spare parts for rotary feeder shaft blue, 2 x 5,0 ccm"
8.10.9. "
Spare parts for rotary feeder shaft black, 2 x 0,25 ccm"
Installing the rotary feeder shaft
1. Insert the shaft into the holder as far as the stop
If this is difficult (e.g. because the rotary feeder shaft is new), the supplied tool can be
used as assistance, by performing slight rotating movements.
2. Put on the cover and turn to the left to lock
