Kunststoffschweißtechnik
Starting
and
operating
Chapter 5
08.10.14 Working
instructions
WIDOS RSC 2000
Page 29 of 63
Remove the pipe pieces and the remaining chips e.g. by vacuum.
C u t t in g is c o m p le t e d .
5.4. How to cut angles
Switch on the saw, drive the distance of the saw blade to reference position
(chapter: 5.2) and calibrate the saw angle (chapter: 5.2.1).
It is possible to cut 45° angles on both sides, 67,5° angles only possible on one
side.
Release the resting
or clamping cylinder
by turning both switches (
and
) to
the right; and shift the saw manually until the requested angle is indicated on the display.
Now turn the switch for the resting cylinder
to the left and let the cylinder snap in,
Or
: turn the switch for the clamping cylinder
to the left in order to have the angle
locked.
Place the pipe onto the pipe supports.
Switch on the laser by
and drive the pipe by the control lever
until the laser
indicates the requested cutting position on the pipe.
Preclamp the pipe first by the clamping belts and afterwards tighten it by both pipe clamping
buttons (chapter: 4.5).
Necessarily put on safety glasses and ear protectors now!!
Switch on the vacuum by:
.
Drive the saw blade by the control lever
and with moderate speed shortly behind the
pipe; the display indicates the current distance to the pipe center resp. the rotational speed
of the travel.
The distance to the pipe during the angle cutting must be larger than:
½ pipe diameter * sin
α
Display:
2
nd
line:
0U/min 0U/min
-2894.4mm 15.0
Rotational speed of saw motor / rotational speed of
saw travel
Distance to pipe center / angle
Reduce the travel when the cutting chain is shortly behind the pipe.
Now press the button on the control lever additionally and cut the pipe through by control
lever
; adapt the rotational speed of the saw motor and the travel to the pipe.
Having cut the pipe through, release the button on the control lever
; the travel stops.
Press the control lever
to the opposite side and drive the saw blade completely to the
rear. As soon as the saw blade is located behind the cut pipe, you may release the control
lever
; the cutting chain stops.
