Kunststoffschweißtechnik
WIDOS
Einsteinstr. 5
Phone ++49 (0)7152 / 9939 - 0
W. Dommer Söhne GmbH D-71254 Ditzingen-Heimerdingen Fax
++49 (0)7152 / 9939 - 40
Internet: www.widos.de
email: [email protected]
08.10.14 Working
instructions
WIDOS RSC 2000
Page 25 of 63
5. Starting and operating
The instructions of this chapter are supposed to initiate in the operation of the machine and
lead during the appropriate starting of the machine. This includes:
the safe operation of the machine
economic operation of the machine.
5.1. Starting
In order to put the saw
RSC 2000
into operation, you must align it by the bolts in the leveling
feet in a way that the table, the pipe support and the guiding of the cutting chain are horizontal
/ vertical.
Connect the mains plug to the local power supply CEE 32 A / 400 V / 14 kW / 50 Hz (right
rotary field).
Connect a pneumatic hose to the local compressed air supply (6 -8 bar) and to the service
unit.
In case of danger for man and machine,
immediately
use the <emergency-stop>
in order to stop the entire system, the saw, the pipe supply and the extruder.
Only cut firmly clamped pipes!
Make sure that no unauthorized person has access to the chain saw.
Protect the chain saw against moisture and humidity!
Regularly
clean the saw, especially the cutting chain, gear rods and threaded
spindles, in shut-off condition! (see also chapter: 6.1 + 6.4).
