Kunststoffschweißtechnik
WIDOS
Einsteinstr. 5
Phone ++49 (0)7152 / 9939 - 0
W. Dommer Söhne GmbH D-71254 Ditzingen-Heimerdingen Fax
++49 (0)7152 / 9939 - 40
Internet: www.widos.de
email: [email protected]
08.10.14 Working
instructions
WIDOS RSC 2000
Page 31 of 63
6. Maintenance / Storage / Transport
Goal of the chapter is:
Keeping the nominal state and the operation capacity of the machine.
Efficient planning of the maintenance work and the maintenance tools.
Increasing the efficiency by avoiding non-planned outage.
6.1. In
general
All maintenance and repair work have to be basically performed with the machine in
off position.
During this, the machine has to be secured against unauthorized switching on.
Prescribed maintenance and inspection work should be performed in time. We
recommend inspection work after 1 year.
For machines with a specially high usage percentage the testing cycle should be
shortened.
The work should be performed at the WIDOS GmbH company or by an authorized
partner.
The linear guides must be cleaned
every week
, e.g. with a brush.
Check the linear guide carriages
every
12 months
and grease them over the
lubricating nipple if necessary.
Dirty guides may cramp and run heavily.
Check the tightness of all screwed connections
every three months
.
You must clean the gear rods and the threaded spindles
weekly
by suction or cloth
in order to remove the sawing chips.
The operating staff has to be informed before the starting of the maintenance work.
Replace damaged parts immediately. Be particularly careful with electric parts
→
dust and
humidity are very much current leading.
Only use original
WIDOS
spare parts for repair work.
Store dry.
Protect the machine from heavy shocks.
Handle the machine carefully.
We basically recommend removing
regularly
any remaining cuttings (switch off the
machine!). For that purpose, detach the cover.
6.2. Storage
If any storage becomes necessary, make sure that the storage room is dry and that the
temperature is b5° C and +35° C.
