Kunststoffschweißtechnik
Operating
and
indicating elements
Chapter 4
08.10.14 Working
instructions
WIDOS RSC 2000
Page 19 of 63
4.3. Laser
(optional)
The line laser Z5 is mounted inwards to the bridge column 1.
The laser beam shows the cutting course on the clamped
pipe.
The light beam is adjusted in a way that it corresponds to the
cutting chain vertically. In case it is misaligned, you will have
to readjust it vertically.
Switch on and shut off the laser by
on the operator
console.
Please gather the exact adjustment of the laser from the
attached working instructions of the manufacturer.
4.4. Pipe supports and prisms
On both sides, you will find mounted pipe supports with prisms and (optional) pipe lifters.
The prisms are guided between the fixing guide rails
inside and the terminal strips outside.
You can adjust the
prisms
depending on pipe
size
and
the pipe
sawing angle
(arrows).
Right picture shows pipe support with one prism. The rows of holes for the fixingguide rails
and terminal strips are marked on the side without a prism, depending on pipe size:
hole patterns for pipe size OD 630 mm up to OD 2200 mm
hole patterns for pipe size OD 1500 mm up to OD 2000 mm
hole patterns for pipe size OD 2200 mm up to OD 2500 mm (not used)
Mount the fixing guide rails and terminal strips with the prisms depending on pipe size on
the pipe support.
Move the prisms depending sawing angle so that the prisms are always close to the saw
cut.
Clamp the positions of the prisms with the clampimg levers.
Laser
Prism
Prism
Terminal strip with clamping lever
Fixing guilde rail
