widos RSC 2000, Working Instructions Translation

Page: 28 / 63

Kunststoffschweißtechnik
Starting and operating Chapter 5
08.10.14 Working instructions WIDOS RSC 2000 Page 28 of 63
press several times button <Start> or after a short while appears
automatically:
Display:
2
nd
line:
693 rpm 690 rpm
-2894.4mm 0.00
Basic menu
5.3. How to make vertical cuts
Switch on the saw, drive the distance of the saw blade to reference position
(chapter: 5.2) and calibrate the saw angle (chapter: 5.2.1).
In case the saw is not in „0°“ position, then shift the saw manually to this position; turn switch:
to the left and lock the saw by having the cylinder snap in.

Place the pipe onto the pipe supports.

Switch on the laser by and drive the pipe by the control lever until the laser
indicates the requested cutting position on the pipe.

First preclamp the pipe by the clamping belts and afterwards tighten it by both pipe
clamping buttons (chapter: 4.5).

Necessarily put on safety glasses and ear protectors now!

Switch on the vacuum by .

Drive the saw blade by the control lever and with moderate speed shortly in front of
the pipe; the display indicates the distance to the pipe center resp. the rotational speed of
the travel.
Display:
2
nd
line:
0U/min 0U/min
-2894.4mm 0.0
Rotational speed of saw motor / rotational speed of
saw travel
Distance to pipe center / angle

Reduce the travel as soon as the saw blade is shortly behind the pipe; it is necessary that
the distance is larger than ½ the pipe diameter.

Now press the button on the control lever and cut the pipe through by control lever ;
adapt the rotational speed of the saw motor and the travel to the pipe.

Having cut the pipe through, release the button on the control lever ; the travel stops.

Press the control lever to the opposite side and drive the saw blade completely to the
rear. As soon as the saw blade is located behind the cut pipe, you may release the control
lever ; the cutting chain stops.

Shut off the laser by .

Shut off the vacuum by .

Release the pipe clamping by both pipe clamping buttons and in addition release the
clamping belts manually.