WhitakerAudio 60 W Stereo Power Amplifier, User And Assembly Manual

Page: 84 / 154

84
WhitakerAudio
Note that the solder connection ties together the black wire, the barrier strip post, and the
PWB mounting post. Use care when soldering to avoid contact with other wiring in the
chassis.
– Cut a 4-inch long #18 yellow wire. Attach a quick-disconnect terminal to one end of the
wire. Using a pair of long-nose pliers, fashion a small loop at the other end of the wire.
Attach to the left channel 8 Ohm terminal from the component side of the PWB. Solder.
Note that the solder connection ties together the yellow wire, the barrier strip post, and the
PWB mounting post. Use care when soldering to avoid contact with other wiring in the
chassis.
– Prepare an 8-inch long #18 black wire. Connect one end to the ground lug on the back
panel that already contains a #18 wire and a #22 wire. Solder (3 wires).
Note: When making connections to the speaker terminal PWBs, support the board as needed
to avoid stressing the PWB.
– Attach a quick-disconnect terminal to the free end of the 8-inch #18 black wire. Attach to
one of the GND posts on the right channel speaker PWB.
– Prepare a 5-inch long #18 black wire. Connect one end to the available ground lug on the
back panel. Solder.
– Attach a quick-disconnect terminal to the free end of the 5-inch #18 black wire. Attach to
one of the GND post on the left channel speaker PWB.
– Find the 4-inch long #18 black wire from the right channel speaker terminal. Attach to the
SPK GND post on the right channel speaker terminal PWB.
– Find the 4-inch long #18 black wire from the left channel speaker terminal. Attach to the
SPK GND post on the left channel speaker terminal PWB.
– Find the 4-inch long #18 yellow wire from the right channel speaker terminal. Attach to
the OUT post on the right channel speaker terminal PWB.
– Find the 4-inch long #18 yellow wire from the left channel speaker terminal. Attach to the
OUT post on the left channel speaker terminal PWB.