WhitakerAudio 60 W Stereo Power Amplifier, User And Assembly Manual

Page: 77 / 154

77
60 W Stereo Power Amplifier
• Red wire to barrier strip Terminal 1 .
• White wire to barrier strip Terminal 2 .
• Black wire to barrier strip Terminal 3 .
Note that barrier strip Terminal 4 is not used.
All connections have now been made to the left channel PWB, except for the Conn1 and
Conn2 audio connection points. All terminal posts should have wires connected to them except
for two GND posts, which are not used in this implementation. Double-check the tightness of the
mounting screws on the PWB, in particular the one with the ground lug on the component side.
– Find the black #22 wires from the two amplifier PWBs. Combine into a single spade
terminal and crimp (2 wires).
– Find the white #22 wires from the two amplifier PWBs. Combine into a single quick-
disconnect terminal and crimp (2 wires).
– Find one of the #18 green wires from the two amplifier PWBs. Combine into a single
quick-disconnect terminal and crimp (2 wires). Double-check to make sure you have one
wire from each PWB.
– Find the other #18 green wires from the two amplifier PWBs. Combine into a single
quick-disconnect terminal and crimp (2 wires).
– Connect the terminals from the two wiring harnesses to the power supply PWB as follows:
• Green wires to TERM5 and TERM6 .
• White wires to TERM7 .
• One of the red wire to barrier strip Terminal 1 . To facilitate installation, bend the barrel of
the spade terminal up slightly.
• The other red wire to barrier strip Terminal 2 . To facilitate installation, bend the barrel of
the spade terminal up slightly.
– Black wires to barrier strip Terminal 4 . To facilitate installation, bend the barrel of the
spade terminal up slightly. Note that no connection is made to Terminal 3.
All connections have now been made to the power supply PWB. All terminal posts should
have wires connected to them except for the following:
• GND (three positions)