30998 R1
41
Figure 29.
Attaching Lower Reach Arms and Cross Member
3
4
5
3
4
5
4
3
2
1
4
3
2
1
8
7
6
4. Lift the spout end of the tube with a front end loader and a strong sling/chain or block and tackle. The
height should be sufficient to clear undercarriage assembly.
5. Position the undercarriage assembly beneath the conveyor assembly.
6. Attach the lower reach arms (1) to the reach-arm bracket with two 5/8" x 1-1/2" bolts (9) and 5/8" locknuts
(10), see
Figure 30
and
Table 21
:
Æ
a.
For Hydraulic Motor Drive (A):
Bolt the lower reach arms to the reach-arm bracket nearest to the
hopper end.
Æ
b.
For Electric Motor Drive (B):
Bolt the lower reach arms to the reach-arm bracket nearest to the spout
end.
Note
Do not over tighten. Tighten snug only, these bolts act as pivot points.
7. Fasten the lift arms (11) to the lower reach arms (1) using two 5/8" x 1-1/2" bolts (9) and 5/8" locknuts (10).
8. Slide two tube clamps (12) over the flat pressed ends of the lift arms (11).
9. Attach the lift arms (11) to the track shoe using 5/8" x 1-1/2" bolts (9) and 5/8" locknuts (10).
Note
Do not over-tighten. Tighten snug only, these bolts act as pivot points.
WCX 1335 TOP-DRIVE CONVEYOR – PORTABLE GRAIN BELT CONVEYOR
4. ASSEMBLY
