W
ESTFIELD
- GULP2 H
OPPER
3. A
SSEMBLY
MKX130
AND
MKX160 M
ODELS
30962 R1
23
3.4.4. Connect the GULP2 Transition to the Swing Tube (160)
1. Attach the GULP2 transition to the swing tube with twelve 5/8” X 1-1/2” bolts
and locknuts.
2. Thoroughly grease two 1-3/4" flat washers, then place them fully onto the end
of the swing flight shaft.
3. Place the bushing support onto the swing flight shaft and secure it in place
with two 3/8" x 1" bolts, 3/8" flat washers and locknuts.
4. Insert a woodruff key into the swing flight shaft, then slide the u-joint onto the
swing flight shaft.
5. Secure the u-joint to the swing flight with a 3/8" set screw, a 5/16" x 2-3/4" bolt
and a locknut.
6. Slide the transition flight shaft into the u-joint.
7. Slide the pillow block bearing over the GULP2 swing flight shaft end that
protrudes through the transition rear end plate.
8. Secure the pillow block bearing to transition rear end plate with two
1/2” X 2” bolts and locknuts.
9. Slide the 1” eccentric collar over the transition shaft until it is pressed against
the pillow block bearing, tighten the collar using a steel punch, then secure
the collar with the collar set screws.
Summary of Contents for GULP2 HOPPER MKX130
