Westfield GULP2 HOPPER MKX130, Assembly & Operation

Page: 17 / 62

W
ESTFIELD
- GULP2 H
OPPER
3. A
SSEMBLY
MKX130
AND
MKX160 M
ODELS
30962 R1 17
3. Assembly
Before continuing, ensure you have completely read and understood this manual’s
Safety chapter, in addition to the safety information in the section(s) below.
3.1. Assembly Safety
• Do not take chances with safety. The components can be large, heavy, and hard to
handle. Always use the proper tools, rated lifting equipment, and lifting points for the
job.
• Carry out assembly in a large open area with a level surface.
• Always have two or more people assembling the equipment.
• Make sure you have sufficient lighting for the work area.
• Tighten all fasteners according to their specifications. Do not replace or substitute
bolts, nuts, or other hardware that is of lesser quality than the hardware supplied by
the manufacturer.
3.2. General Assembly
The GULP2 hopper is available installed as part of the normal assembly of an MKX130
or MKX160 auger, as an option in place of the low profile hopper, or as a kit to replace an
already-installed low-profile hopper.
Refer to the appropriate assembly manual for general assembly information, including
auger assembly sequence and the standard list of tools required (installation of the
GULP2 hopper replaces the installation of the Low Profile hopper in the auger assembly
sequence).
See Table 3.1 for a list of assembly procedures required to assemble and install a
GULP2 hopper, presented in the sequence that they should be performed.
Table 3.1 GULP2 Assembly Procedures
# Procedures Page
1 Verify Auger Assembly page 18
2
Replace the Swing Tube Flight (130)
a
page 21
3
Remove the Transition (160)
a
page 21
4
Connect the GULP2 Transition to the Swing Tube (130)
a
page 21
5 Connect the GULP2 Transition to the Swing Tube (160) page 23
6 Attach the GULP2 Hopper to the Transition (130/160) page 27
7 Install the 3-Spool Valve (130/160) page 28
8 Attach the End Ramp (130/160) page 29
9
Connect the Hydraulic Hoses to the 3-Spool Valve (130/160)
b
page 30
10 Install the Hydraulic Winch (130/160) page 32
a. Only required for GULP2 kit to replace a low-profile hopper.
b. The 3-Spool hydraulic control valve can be converted between closed center and open center by installing
the appropriate conversion plug on the valve. See “Open/Closed-Center Valve Conversion” on page 57.