EN
18
Light Array Operation
5.1.2 Using the SZ0-LAH1 Aligning Tool
The Laser Aligning Tool simplifies alignment of the safety device over great distances.
The same procedure is used as described under “Using the RF Aligning Tool”, except that in this case highly vis-
ible laser light is used.
5.1.3 Adjustment Procedure
Start
Set all Dip
switches to off
Align the Safety Light
Array mechanically
Press an hold the
enter key on the
receiver for 1 s
Do the
blanking alignment
and failure LEDs
blink?
Degree of
alignment appears
at the display
99 – very good
44 – not good
43 – rays masked
see table “Degree of alignment
against the distance between
transmitter and receiver”
The Safety Array is
ready for operation
Display at receiver
Serial Communication
Cascading
Timing
Restart Inhibit
8
7
6
5
4
3
2
1
ON OFF
Contactor Monitoring
Reduced Resolution
Fix Blanking
S1
Function Mode:
Safety Operation Mode
DIP Switch Settings: Receiver
yes
Improve
Alignment
no
Press and hold the
nter key on the
receiver for 1 s
The receiver boots
and activates the
output
Distance transmitter – receiver
Without tilted mirror
With 1 tilted mirror
With 2 tilted mirrors
Degree of alignment
≤
3 m
≤
2,7 m
≤
2,4 m
96 imperatively necessary
3...20 m
2,7...18 m
2,4...16 m
96, 78, 68, 56 preferred
> 43 necessary
Tab.: Degree of alignment against the distance between transmitter and receiver
