WEIHONG LS6000M, Manual

Page: 4 / 121

上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD
.
1 / 116
1 Quick Start
1.1 Overview
This section introduces the hardware and software of the NcStudio V15 laser cutting
control system .

Hardware
o
PM95A motion control card
o
Lambda controller

Non-bus control systems: Lambda 5E controller

Bus control systems: Lambda NE controller
o
EX33A extension terminal board (for follow control)
o
EX31A extension terminal board (for extension of terminal board ports)
o
SE001 follow-up amplifier
o
DB9M/F communication cables * 2
o
RF cable * 1
o
M16 three-core aviation plug towline cable * 1
o
WHB05L wireless handwheel / WHB05N wireless handwheel
For hardware connection diagram, see Hardware Connection Diagram.

Software
For introduction of the software interface of the NcStudio V15 laser cutting
control system , see introduction of the software interface.
1.2 Hardware Connection Diagram
The connection method varies based on the control system type.
Non-bus control systems
The connection diagram is shown below: