21
12
24. Wrap the Press Cable (80) around a 90mm
Pulley (37). Attach the Pulley to the indicated side
of the Press Frame (14) with an M10 x 85mm
Bolt (88), an M10 Washer (95), and an M10
Nylon Locknut (74).
24
22.
Locate and open the parts bag labeled
“CABLE ASSEMBLY.” For cable identification
and routing during steps 22 to 52, refer to the
CABLE DIAGRAMS and CABLE ID CHART on
page 26.
Do not overtighten the nylon locknuts attach-
ing the pulleys to the weight system; the pul-
leys must be able to turn freely.
Identify the Press Cable (80). It is approximately
393.41” long and it has a ball on one end and a
loop on the other. Wrap the Press Cable around a
90mm Pulley (37). Attach the Pulley to the Press
Top Frame (13) with an M10 x 90mm Bolt (55),
an M10 Washer (95), and an M10 Nylon Locknut
(74).
Be sure that the Cable is between the
Pulley and the rod on the Press Top Frame,
and that the ball is on the side shown.
22
23
37
95
80
74
Rod
Ball
13
55
44
62
21. Press four M10 Brass Bushings (77) into the Leg
Press Arm (22) and the Press Base (3).
Lubricate an M10 x 85mm Bolt (88). Orient the
Leg Press Arm (22) as shown. Attach the Leg
Press Arm to the Press Base (3) with the Bolt and
an M10 Nylon Locknut (74).
Do not overtighten
the Nylon Locknut; the Leg Press Arm must
be able to pivot easily.
3
74
77
22
Lubricate
88
80
74
80
37
95
14
88
37
Cable Assembly
23. Loosen the M10 Nylon Locknut (not shown) on
the indicated M10 x 95mm Bolt (62). Wrap the
Press Cable (80) around the 90mm Pulley (37),
making sure the Cable is between the Pulley and
the Cable Trap (44). Re-tighten the Nylon Locknut.