1.
Before beginning, make sure that you have
read and understood the information on page 5.
Locate and open the parts bags labeled
“FRAME ASSEMBLY 1 and 2.”
Press a 50mm Square Inner Cap (59) into each
end of the Butterfly Base (1).
Insert four M10 x 65mm Carriage Bolts (76) up
through the Butterfly Base (1). Place the Butterfly
Base flat on the floor.
Note: If the Bolts fall out,
secure them with a small piece of tape.
Attach the Center Base (2) to the Butterfly Base
(1) with two M10 x 70mm Bolts (58), a Long
Support Plate (34), and two M10 Nylon Locknuts
(74).
Do not tighten the Nylon Locknuts yet.
2.
Press a 50mm Square Inner Cap (59) into each
end of the Press Base (3).
Orient the Press Base (3) so that the indents
around the bolt holes are on the bottom. Insert six
M10 x 65mm Carriage Bolts (76) up through the
Press Base. Place the Press Base flat on the
floor.
Note: If the Bolts fall out, secure them
with a small piece of tape.
Attach the Press Base (3) to the Center Base (2)
with two M10 x 70mm Bolts (58), a Long Support
Plate (34), and two M10 Nylon Locknuts (74).
Do
not tighten the Nylon Locknuts yet.
1
3.
Orient the Butterfly Upright (4) as shown. Attach
the Butterfly Upright to the indicated M10 x 65mm
Carriage Bolts (76) in the Butterfly Base (1) with
two M10 Nylon Locknuts (74).
Do not tighten the
Nylon Locknuts yet.
3
6
Frame Assembly
2
58
34
74
74
59
76
76
59
1
74
1
4
74
76
2
58
76
76
76
74
74
2
34
3
59
59
