8.
Attach the Top Frame (5) to the Butterfly Upright
(4) with two M10 x 70mm Bolts (58), a Short
Support Plate (26), and two M10 Nylon Locknuts
(74).
Do not tighten the Nylon Locknuts yet.
Note: Be sure that the Top Frame (5) is orient-
ed so that the pulley brackets are closer to
the back of it, and that it rests between the
Weight Guides (33) as shown in step 9.
Attach the Top Frame (5) to the Press Upright (6)
in the same manner.
9.
Attach each set of Weight Guides (33) to the Top
Frame (5) with an M10 x 155mm Bolt (89), two
M10 Washers (95), and an M10 Nylon Locknut
(74).
Do not tighten the Nylon Locknuts yet.
8
8
7.
Slide a Weight Carriage (28) onto each set of
Weight Guides (33).
Be sure the weight tubes
are near the top of the Weight Carriages.
7
33
33
5
89
58
58
28
28
33
33
26
26
Pulley Bracket
74
95
95
33
33
74
5
74
4
6
Weight
Tube
10. Press three 50mm Square Inner Caps (59) into
the Butterfly Top Frame (19).
Attach the Butterfly Top Frame (19) to the
Butterfly Upright (4) with two M10 x 70mm Bolts
(58), a Long Support Plate (34), and two M10
Nylon Locknuts (74).
Attach the Butterfly Top Frame (19) to the Top
Frame (5) with two M10 x 70mm Bolts (58), a
Long Support Plate (34), and two M10 Nylon
Locknuts (74).
Do not tighten the M10 Nylon Locknuts (74)
yet.
10
9
4
74
74
74
5
19
34
59
59
59
58
58
