4.
Press a 38mm Square Inner Cap (75) into the
indicated tube on the Press Upright (6).
Orient the Press Upright (6) as shown. Attach the
Press Upright to the indicated M10 x 65mm
Carriage Bolts (76) in the Press Base (3) with two
M10 Nylon Locknuts (74).
Attach the Support Brace (7) to the indicated M10
x 65mm Carriage Bolts (76) in the Press Base (3)
with two M10 Nylon Locknuts (74).
Attach the Support Brace (7) to the Press Upright
(6) with two M10 x 70mm Carriage Bolts (58), two
M10 Washers (95), and two M10 Nylon Locknuts
(74).
Do not tighten the M10 Nylon Locknuts (74) yet.
4
7
5.
Press two 25mm Round Inner Caps (32) into the
ends of the weight tube on a Weight Carriage (28).
If you will be using Olympic weights with the
weight system, slide a Weight Sleeve (27) onto
each end of the weight tube on the Weight
Carriage (28). Secure each Weight Sleeve with a
Locking Pin (31).
Note: The drawings in this
manual show the Weight Sleeves attached.
The Locking Pins will be found in the bag
labeled “CABLE ASSEMBLY.”
Repeat this step with the other Weight Carriage
(28).
5
74
74
75
74
74
74
32
31
31
3
76
58
95
6
7
76
28
Weight
Tube
6.
Press a 38mm Round Inner Cap (67) into each
bumper tube on the Center Base (2). Press a
Weight Bumper (56) onto each bumper tube.
Attach two Weight Guides (33) to the indicated
tube in the Center Base (2) with an M10 x 155mm
Bolt (89), two M10 Washers (95), and an M10
Nylon Locknut (74).
Do not tighten the Nylon
Locknuts yet.
Attach the other set of Weight Guides (33) in the
same manner.
6
89
95
95
33
33
74
Bumper
Tube
Tube
67
67
56
56
2
27
27
