21
56
64
57
90
90
66
51
6
70
21
84
98
63
54
20
57. Press a 45mm Square Inner Cap (60) into the
back of the Adjustment Tube (23).
Attach the Adjustment Tube (23) to the Press
Plate (24) with an M10 x 60mm Bolt (79), two
M10 Washers (95), and an M10 Nylon Locknut
(74).
Note: Be sure the long edges of the
Adjustment Tube and the bracket on the Press
Plate are on the top.
Attach the Adjustment Tube (23) to the Leg Press
Arm (22) with the Press Pin (46).
57
74
79
22
24
46
60
23
95
95
70
58
39
73
73
73
73
Welded
Tube
41
41
41
41
8
39
9
58. Press four 19mm Round Inner Caps (73) into the
ends of the Pad Tubes (39).
Insert the Pad Tubes (39) into the welded tube on
the Butterfly Front Leg (9) and the hole in the Leg
Lever (8). Slide a Foam Pad (41) onto each end
of the Pad Tubes.
56. Press a 25mm x 40mm Inner Cap (63) into the
back of the Backrest Bracket (21). Press two
25mm x 50mm Inner Caps (70) into the top and
bottom of the Backrest Bracket.
Insert an M8 x 40mm Carriage Bolt (54) into the
center hole of the Support Plate (57). Attach the
Support Plate to Press Backrest (20) with two M6
x 16mm Screws (90). Attach the Backrest to the
Backrest Bracket (21) with the Carriage Bolt, an
M8 Washer (66), and an M8 Nylon Locknut (64).
Attach the top of the Backrest to the Backrest
Bracket with an M6 x 45mm Screw (98) and an
M6 Washer (84).
Loosen the Adjustment Knob (51) by turning it
counterclockwise, and pull it out as far as possi-
ble. Insert the Backrest Bracket (21) into the
Press Upright (6) and align an adjustment hole
with the the Adjustment Knob. Snap the Knob into
the adjustment hole and turn it clockwise until it is
tight.