82
6
DETAILED PARAMETER DESCRIPTION
• External Error:It can be programmed for any Digital Input
DI2, DI3 or DI4. If there is no external error,
there is also no actuation. If more than one
digital Input has been programmed for
"External Error", any input will actuate, when
disconnected from +24Vdc (X2:5).
• Error Reset: The Error Reset is accepted via HMI-3P, serial
and Digital Inputs DI2, DI3 or DI4, when so
programmed. If more than one Digital Input
if programmed, any one can reset the error
status, requiring only the receipt of a +24Vdc
(X2:5) pulse.
6.4.14 - P62 - Address
of the Soft-
Starter at the
communica-
tion network
This parameter defines the address of Soft-Starter on
the communication network. This is for use with the
superdrive software.
OFF, ON
Possible Values
Factory
Standard
ON
P61 -
Command Enabling
Extern Error
X
Only at the Digital Input 2, 3 or 4.
Error Reset
X
X
X
avaliable at any.
Commands
Digital Input
Description
HMI
Serial
Table 6.2 -
Controls that do not depend on the setting of P61
and also via serial (provided P61=ON). If
more than one Digital Input is programmed
for this function, the first that opens will be
the emergency stop. If the command is also
enabled for serial operation (P61=ON), all
Digital Inputs programmed to General
Enabling must be closed.
