3. REPAIRS
23
12.
Mount the new gearwheel. Being sure to center it evenly between the walls of the hole in the motor
bracket. Note that the core or center of the gear has splines (teeth). The splines do not extend
completely to one side of the gears inner core. This is the down (bottom) side in car position for
mounting (figure 3.5.3).
Figure 3.5.3
13.
Mount the new gearwheel housing.
14.
Mount the SCU. Dropping the front of the SCU low enough for cable clearance slide forward, engage
lip of cable plate in SCU slot. Straighten SCU horizontally and tighten screw.
15.
Connect the motor to the SCU. (wire one way connector).
16.
Remount motor and cover, replace screws.
17.
Calibrate the SCU as described in chapter 2.2.5.
17.
Inspect the sunroof for proper electrical and mechanical functions.
18. Remount
headliner.
19.
(For the HOLLANDIA 700 - 20 series) Slide the trim tray forwards and connect the trim tray (103) to
the drain channel.
(For the HOLLANDIA 700 - 40 series) Remount the LH mechanism cover.
20.
Final inspection of unit.
Summary of Contents for HOLLANDIA 700 - 20 Series
Page 2: ...2 ...