14
Power Up
(Cont.)
The third line indicates the ambient temperature the processor is measuring. Check to make sure the
temperature is accurate. If the processor has been in direct sunlight or has been moved from a hot or
cold environment, the temperature may not be correct. If the temperature indicated is not correct, al-
low the processor time to adapt to the correct temperature, approximately 15-20 minutes.
See page
32 for additional instructions about fusing in environments at low ambient temperatures.
NOTE:
Fusions performed in ambient temperatures less the 50°F may require additional preparation
and instruction. If the RF-3000LE Electrofusion Processor reads an ambient temperature
of less than 50°F, it will display the following message screen before proceeding to the
CONNECT LEADS screen:
See page 33 for Warning & Error Code Definitions. See page 32 for more information about fusing
in low ambient environments.
The last line on the CONNECT LEADS screen indicates the generator status. The voltage and the
frequency are displayed. It is important that the voltage measurement is within the allowable range
and the frequency is stable.
See Specifications Table on page 6.
Pressing and holding down the UP button while the processor is at the CONNECT LEADS screen will
show a screen similar to the following:
This screen shows the following information:
• Software version of the processor (In this case, version 1.2.3).
• Processor serial number (In this case, 8540123).
• The number of fusions the processor has completed (In this case, 124).
• The Date and Time (In this case, May 11, 2018 at 3:30 PM).
• The date the processor will be due for calibration (In this case, May 11, 2020).
Release the
UP button
to return to the CONNECT LEADS screen.
To begin the fusion process, start by connecting the
Output Leads
to the fitting.
NOTE:
If connecting more than one fitting at a time, consult page 25 for additional instructions.
General Operation
WARNING 53 RECEIVED
Low Temp Advisory
Call Orion Eng
Press START to clear
VER: 1. 2. 3 SN: 8540123
FC: 0124
05/11/2018
15: 30
CAL DUE - 05/11/2020