Page
step 4: instAlling the lAnDing skiD
❑
Cut away the covering material from over the landing skid mounting slot
in the bottom of the fuselage.
❑
Glue the landing skid into place, making sure that the mounting tab is
flush with the bottom of the fuselage.
you'll neeD the FolloWing pArts From the kit:
bottom AnD Center Wing instAllAtion
you'll neeD the FolloWing tools AnD supplies:
❑
Kwik Bond Thin and Thick C/A
❑
# 1 and # 2 Phillips Head Screwdrivers
❑
Excel Modeling Knife
❑
(1) Center Wing
❑
(1) Bottom Wing
❑
(2) Outer Wing Struts (Down)
❑
(4) M2 x 8mm Wood Screws
❑
(1) Center Wing Fairing
❑
(4) M3 x 25mm Machine Screws
❑
Scissors
❑
220 Grit Sandpaper with Sanding Block
❑
Masking Tape
step 1: instAlling the bottom Wing
❑
Apply a couple of drops of thin C/A into the bottom wing mounting holes
in the fuselage and let it dry completely.
❑
Cut away the covering material from over the top and bottom of the
wing-screw mounting holes in the bottom wing, then cut away the
covering material from over the outer wing strut mounting slots in the top of
the wing.
❑
Mount the wing to the fuselage, using the two M3 x 25mm machine screws
provided.
IMPORTANT
Be careful not to overtighten the machine screws. The
screws need only be tightened snugly.
