Page
❑
With both the rudder and the rudder servo centered, cut off the pushrod
right at the front of the control horn.
❑
Attach the remaining prebent wire into the outermost hole in the control
horn, then secure it to the pushrod, using the remaining piece of the
heat-shrink tubing.
IMPORTANT
Remember to double-check that both the rudder and the
rudder servo are centered before shrinking the heat-shrink tubing.
you'll neeD the FolloWing pArts From the kit:
lAnDing geAr instAllAtion
you'll neeD the FolloWing tools AnD supplies:
❑
Kwik Bond Thin C/A
❑
# 1 Phillips Head Screwdriver
❑
Excel Modeling Knife
❑
(1) Gear Wing
❑
(2) Main Gear Wheels
❑
(1) Carbon Fiber Axle
❑
(4) Rubber Wheel Retainers
❑
(2) Landing Gear Struts
❑
(4) Aluminum Brackets (U-Shaped)
❑
(2) Aluminum Brackets (Straight)
❑
(12) M2 x 8mm Wood Screws
❑
Electric or Hand Drill
❑
1/16" (1.6mm) Drill Bit
step 1: instAlling the Wheels
❑
Cut away the covering material from over the axle mounting hole in each
end of the gear wing.
❑
Slide the carbon fiber axle through the gear wing and center it.
❑
While holding the axle centered, slide one rubber wheel retainer onto
each end of the axle and push them up against the ends of the gear wing.
IMPORTANT
After installing the rubber wheel retainers, double-check that both wheels spin freely.
❑
Slide one wheel onto each end of the axle, then slide the remaining
rubber wheel retainers onto the axle to hold the wheels in place.
IMPORTANT
The molded ribs in the wheels should be toward the
outside.
