Watlow PM PLUS™ 6
•
76
•
Chapter 7: Factory
Factory List
Display
Parameter Description
Range
Default
Parameter
ID
IP Actual Ad-
dress Part 2
Actual IP address of this module.
Note:
This is
read only here. Go to
Operations — Setup — Com-
munications
to change.
0 to 255
254
17045
IP Actual Ad-
dress Part 3
Actual IP address of this module.
This is a read
only parameter here. Go to
Operations — Setup —
Communications
to change.
0 to 255
1
17046
IP Actual Ad-
dress Part 4
Actual IP address of this module.
Note:
This is read only here. Go to Setup - Commu-
nications to change.
0 to 255
1
17047
Operations — Factory — Calibration —
You may see Calibration 1, Calibration 2, or Calibration 3, depending on the configuration of your device.
Electrical Mea-
surement
Read the raw electrical value for this input in the
units corresponding to the Sensor Type setting
in
Setup - Analog Input.
-3.4e38 to 3.4e38
4021
Electrical Input
Offset
Change this value to calibrate the low end of the
input range.
-1,999.000 to 9,999.000
0.0
4010
Electrical Input
Slope
Adjust this value to calibrate the slope of the
input value.
-1,999.000 to 9,999.000
1.0
4011
Electrical Out-
put Offset
Change this value to calibrate the low end of the
output range.
-1,999.000 to 9,999.000
0.0
18005
Electrical Out-
put Slope
Adjust this value to calibrate the slope of the
output value.
-1,999.000 to 9,999.000
1.0
18006
Part Number
Displays current setting for control model num-
ber.
Factory
User
Factory
- - - -
Public Key
Changes the control to user mode or back to
original configuration/model number.
2501 = User Settings
606 = Factory model number
4999
- - - -
