Watlow PM PLUS™ 6
• 59 •
Chapter 5: Setup
Setup Lists
You will not see every parameter listed here. These vary depending on the features enabled on your device.
Clear Alarm
Clears the alarm instance
Clear (0)
Ignore (204)
- - - -
9013
Silence Alarm
Silences the alarm instance. If an alarm is
setup to silence alarm when active the display
will state this. Do not mistake this param-
eter for "
Operations - Setup - Alarm - Alarm
[1,2,3,4] - Silencing
" which turns the ability to
silence alarms on or off.
Silence (1010)
- - - -
9014
Alarm State
Current state of alarm
Startup (88)
None (61)
Blocked (12)
Alarm low (8)
Alarm high (7)
Error (28)
- - - -
9009
Current List
Operations — Setup — Current —
Sides
Select which side or sides will be monitored.
Off (62)
High (37)
Low (53)
Both (13)
off
15005
Indicate Reading
Use to display solid-state relay (SSR) failure
and heater failure messages.
No (59)
Yes (106)
no
15004
Input Detection Thresh-
old
For factory adjustment only.
3 to 59
9
15012
Input Scaling
Adjust scaling to match the transformer's high
range.
0 to 9,999.000
50.0
15022
Heater Offset
Calibrate the current reading with an offset
value.
-9,999.000 to 9,999.000
0.0
15011
Monitored Output
Select which output instance the current trans-
former will monitor.
1 to 12
1
15019
High Set Point
Set the current value that will trigger a high
heater error state.
-1,999.000 to 9,999.000
50.0
15008
Low Set Point
Set the current value that will trigger a low
heater error state.
-1,999.000 to 9,999.000
0.0
15009
Timer List
Operations — Setup — Timer [1] —
Timer Enable
Enable the timer function.
Yes (106)
No (59)
Yes
31029
Timer Start Method
Select what will start the timer.
Immediate (1049)
Ready Band (1942)
Ready Ack (1950)
Power (73)
Immediate
31030
Source Function A
Select which input will start or terminate the
timer.
Function Key (1001)
None (61)
Digital I/O (1142)
Function Key
31001
Source Instance A
Select an instance of Function A.
1 to 24
8
31003
