35
TROUBLESHOOTING
- MONITOR NOT GIVING ANY SCORES. READING ZEROS WHEN ROWING.
1. Check the sensor is plugged in and in the correct port.
2. Check pulses procedure. If no pulses continue with steps 3 & 4.
3. Check for damage to the cable.
4. Contact your local Slider agent for further advice or replacement cable.
- MONITOR NOT TURNING ON.
1. Replace batteries.
2. If the batteries have been replaced with new and in date batteries and
still does not turn on contact your local Slider agent for further advice or
replacement monitor.
- MONITOR GIVES IRREGULAR SPEED AND RATINGS.
1. Check pulses procedure. If there is a regular pulse at low speed check again
at a progressively higher flywheel speed. Listen for consistency of beeps as
the speed of the flywheel increases.
2. If there are inconsistent beeps it means that the sensor is not detecting the 3
magnets per revolution and therefore producing some irregular scores and
ratings.
3. If this is the problem you identify please contact your local Slider agent for
further advice.
CHECK PULSES PROCEDURE
1. Turn monitor
ON
.
2. Press the
ARROW UP
button. The small interval digits should appear in the
centre bottom field of the display.
3. Press the
ARROW UP
until the digit reads 01, then press
READY
. The top right
corner field should then show a number digit only.
4. Lightly pull the handle to get the flywheel moving. The flywheel contains
3 evenly spaced magnets and as each magnet passes over the monitor
sensor, there should be a beep. ie. 3 beeps per revolution.
5. Try moving the flywheel faster and listen for an even and consistent beep
pattern.
6. If hearing an irregular pattern of beeps or missing beeps please contact your
local Slider agent for further advice.
Summary of Contents for Be Dynamic Slider
Page 1: ...ASSEMBLY MANUAL OWNER S MANUAL MONITOR MANUAL ...
Page 2: ...2 ...
