![background image](http://html1.mh-extra.com/html/waterlogic/purezza-wl2fl-firewall/purezza-wl2fl-firewall_manual_3644358062.webp)
WL2FL
Manual
Page 64 – Revision AUS-04-23
11.
Water does not dispense from Unit
Possible Reason
Solution
Too much water pressure.
Recommend 2.5 to 3 bar for
the
WL2FL Water Treatment
System
to operate properly.
The correct input water pressure is critical to the performance of the
unit to allow solenoids to open.
Check water pressure at the inlet bulkhead with a water pressure
gauge.
Additional method of verification is to turn off water to unit and
press the dispense button. Does the solenoid open without water
pressure to the unit? Listen for solenoid to activate, not button
“click”.
Adjust water pressure to 2.5-3bar.
Closed water supply valve
Open the water supply valve.
The unit is not properly
plugged into electrical outlet
Check electrical outlet connection, or for blown circuit breaker.
Red Heater & Compressor
Switch button on unit is in the
off position
Turn Red Heater & Compressor Switch on.
I = ON
10 Amp Fuse Blown
Replace the 10 Amp Fuse as needed.
Water is present in the Bottom
Tray, causing the Leak
Detection to trigger
Remove the Top Cover and Front Panel. Tip the unit slightly to
drain, dry Bottom Tray completely.
Hot and Cold Solenoid
connections into the Display
PCB are loose.
Turn power off; unplug the
WL2FL Water Treatment System
and
visually inspect Solenoid connections into the Display PCB. Verify
the soldering points on connections are secure into the board.
Remove the PCB to inspect the front of the board.
Exhausted Filter
Replace filters as needed.
Summary of Contents for PUREZZA WL2FL FIREWALL
