Waterco OXISWIM, Installation And Operation Manual

Page: 16 / 45

OXISWIM MANUAL
P a g e 16 | 45
6 SYSTEM I NSTALL
ENSURE THE POWER TO THE SYSTEM AND GPO's OFF AT THIS POINT
6.1 Install the Controller Panel
6.1.1 Install the wall-mounted panel, ensuring that the POWER supply is OFF
6.1.2 Plug the pool pump into the GPO outlet marked 'PUMP', ensuring the POWER is
OFF at the GPO.
6.1.3 Install the Hydroxyl Radical Generator as per the diagram on the inlet side of the
filter. For additional information regarding the Hydroxyl Radical Generator, please
refer to the instruction manual located in the box that contains the Hydroxyl
Radical Generator.
6.1.4 Connect the chemical dosing tubes as per the diagram. Use blue tube for acid and
yellow tube for hydrogen peroxide/chlorine. Use the tapping saddle provided to
connect the acid feed in an appropriate position based on the installation
diagram. Refer to 6.2 for instructions on how to install a tapping saddle.
Refer to 6.3 and 6.4 on how to fit the chemical tube to injectors and foot valves.
6.1.5 Plug the power cord from the Hybrid system into a 10amp power outlet. Ensure
the POWER supply is off until ready to commission the unit.
6.1.6 Plug the Oxiswim Sanitiser (OS) unit into the GPO located on the Oxiswim
controller board. Switch the OS unit to the on position (refer to instructions of the
OS). The OS will automatically come on when the pump is signalled to operate.
The OS should always be on in conjunction with the system in either Fresh Water
or Chlorine mode
NOTE
Note on Filters Warranty.
Waterco will honour the warranty of all Waterco media and cartridge filters
when used with the Hybrid System, as their construction materials are
designed to withstand the injection of hydrogen peroxide. Waterco can't
support the use of any other brand of filters for use in a Hybrid System pool