Page 22 of 68
Doc. P/N: WSP-009-002
Version: V2.3
Issue Date: July 2014
Installation Manual
www.wassp.com
Mounting Instructions – Transceiver
Transceiver Installation Considerations
For maintenance purposes, the PCB assembly can be removed from the case in
situ. Always leave at least 600 mm clearance at the faceplate end cover to allow
the PCB assembly to be withdrawn from the case.
Transceiver Installation
Using the mounting flanges on the end covers, the transceiver can be mounted
vertically on a bulkhead, or horizontally on the floor. See Figures 5 and 13 for
transceiver dimensions and mounting clearances.
1)
Using the mounting holes on the mounting flanges, secure the transceiver to
the mounting surface.
2)
Connect the following cables to the faceplate end cover. See
Interface
Connections
for cable connection details:
• Transducer cable to Transceiver. See page 25 for details.
• Personal Computer CAT5 cable to Transceiver
• 24V DC power to Transceiver
80
Vertical Bulkhead Mounting
Horizontal Floor Mounting
Drawing not to scale
All sizes in millimeters
535
535
497
Mounting
holes
172
221.5
456
Figure 13 – Transceiver Mounting Diagram
The transceiver can be mounted with
the transducer cable feeding in from
the top. WASSP Ltd. do not recom-
mend this as any water leaks could
run down any of the cables attached to
the faceplate and enter the transceiver.
Installation Manual
