Page 43 of 68
Doc. P/N:
WSP-009-002
Version: V2.3
Issue Date: July 2014
Installation Manual
www.wassp.com
It is best to start the slider from the right
hand side and move to the left until you
see less interfering pulses on the sonar
display.
This filter will also remove bottom
detections which intersect with
interfering pulses.
Single Beam IF
- This is a new filter
just for the single beam display. It will
remove interfering pulses from the
sonar data.
NOTE: this will leave holes where these
pulses occurred.
LOW = remove large pulses
MED = remove large & medium pulses
HIGH = remove large, medium and
small pulses
Above: Example of noisy system with fish echoes. Un-
filtered single beam display.
Above: Filtered single beam display:
