Page 17 of 68
Doc. P/N:
WSP-009-002
Version: V2.3
Issue Date: July 2014
Installation Manual
www.wassp.com
Figure 10 – Inverter Mounting Bracket Outline and Dimensions
Drawing not to scale
All sizes in millimeters
INPUT
LEVEL
LOAD
LEVEL
FAULT
FREQ.
50Hz
60Hz
PURE SINE W
AVE INVERTER
AC OUTPUT
OFF
ON
72
SIDE VIEW
180
ON
OFF
REMOTE
AC OUTPUT
INPUT
LEVEL
LOAD
LEVEL
PURE SINE WAVE INVERTER
STATUS
FREQ.
PWR.
SAV.
S4
S3
S2
S1
TOP VIEW
273
37.5
37.5
308
166 180
35
7
7
Inverter
Outline and Dimensions
Figure 10 shows the physical dimensions of the optional WASSP Ltd. supplied
inverter. If installing the inverter, carefully read the supplied manufacturer’s user
manual and install and operate the inverter accordingly ensuring the environment
is:
1)
DRY – Do not allow water to drop on or enter the inverter.
2)
COOL – The ambient air temperature should be between 0°C and 33°C
- the cooler the better.
3)
SAFE – Do not install the inverter in a battery compartment or other areas
where flammable fumes may exist, such as fuel storage areas or engine
compartments.
4)
VENTILATED – The inverter must be well ventilated at all times. Ensure
there is at least 25 mm of space around the inverter. Ensure the ventilation
fan and air holes are not obstructed at both ends of the inverter.
5)
DUST FREE – Do not install the inverter in a dusty environment as the
dust can be drawn into the unit when the fan is operating.
6)
CLOSE TO BATTERIES – Do not install the inverter in the same compart-
ment as batteries. Do not mount the inverter where it will be exposed to
the gasses produced by the battery, as these are corrosive and prolonged
exposure will damage the inverter. Avoid excessive cable lengths. Use the
recommended wire lengths and sizes (detailed in Section 3-6 of the user
manual).
