You must first enable your reader to read barcodes in order to use
this section. If you have not done this, go to
and complete the appropriate procedure.
Configuration Using Barcodes
26
Wasp WDI7500/WWS750
To program features:
1. Scan the ENTER/EXIT PROGRAMMING barcode, available at the top of
each programming page, when applicable.
2. Scan the barcode to set the desired programming feature. You may
need to cover unused barcodes on the page, and possibly the facing
page, to ensure that the reader reads only the barcode you intend to
scan.
3. If additional input parameters are needed, go to
,
and scan the appropriate characters from the keypad.
Additional information about many features can be found in the “Ref-
erences” chapter.
If you make a mistake before the last character, scan the CANCEL bar-
code to abort and not save the entry string. You can then start again
at the beginning.
4. Complete the programming sequence by scanning the ENTER/EXIT
PROGRAMMING barcode to exit Programming Mode.
For more detailed descriptions, programming information and examples for
setting selected configuration items, see
References, starting on page 228
.
