Enter/Exit Programming Mode
224
Wasp WDI7500/WWS750
Bluetooth Friendly Name
You can set a meaningful name for Wasp WWS750 that will appear in the
application during device discovery.
To set a new Bluetooth Friendly Name, scan the barcode below and follow
the instructions.
Bluetooth Reconnect Attempt Mode
Enable/Disable reconnection by trigger pull.
$CBTRM00(CR)
Bluetooth Reconnect Attempt Mode = Disable
$CBTRM01(
Bluetooth Reconnect Attempt Mode = Enable
DEFAULT
Set Bluetooth Friendly Name
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE barcode above, then the barcode at
left followed by a maximum 64 digits from the Alpha-
numeric characters in
digits must be the hexadecimal ASCII representation of
the desired characters. If less than the expected string
of 32 characters are selected, scan the ENTER/EXIT
barcode to terminate the string.
Make a mistake? Scan the CANCEL barcode to abort
and not save the entry string. You can then start again
at the beginning.
CANCEL
$CBTFN
~
DEFAULT
Wasp WWS750
[SERIAL_NUMBER_SCANNER]
