35
4.6.6 Networking
WebMasterONE Controllers via Ethernet
Equipment Required
An Internet-ready computer.
An Ethernet cable connection between each WebMasterONE using a hub or connection to
LAN.
Utilities you need to set up on your computer
There are no special drivers, adapters or other software components required on the PC to
support networking. Refer to the previous sections for connecting to the master controller via
USB, Ethernet, or modem.
Parameters that need to be programmed into the WebMasterONE
Prior to attempting an Ethernet connection, the following information needs to be entered into
the Communication page of each WebMasterONE on the network, either via an USB
connection or via the local keypad.
The Ethernet IP address of the WebMasterONE.
The Subnet Mask.
The Gateway IP address.
The master must be selected as the master, and the slaves selected as slaves.
Steps Required to Establish a Connection
Connect to the master controller using one of the methods described in sections 4.6.1
through 4.6.5.
The sign-on screen of the WebMasterONE will come up. Type the User Name and
Password (Access Code) in the text boxes and click the Submit button. The default user
name is "webmaster" and the default passwords are "2001" for full access, "2002" for
calibration only, and "2003" for read only. These defaults can and should be changed in
the Access Code page.
Once connected to the master, you may connect to the slaves by clicking on the link under
the heading of “Sub-Network”.
You must log onto each slave using its user name and password.
Hub
Web Browser connected
using any of the
previous methods
Master
Slaves
