S
TARTING
UP
AND
OPERATING
C
HAPTER
7
THP 94/42 R 4 XXT
THP 125/42 R 4 XXT
THP 140 H/42 R 4 XXT
GB-07.2005
7-21
7.5.6
Water pump
The control lever “Water pump” (Item 4, Fig. 7.24) switches the water pump on.
The manometer Item 1, Fig. 7.24) shows the actual pressure at the agitator / water pump (optionally: high pressure
water pump and compressor). The maximum pressure that can be set is 210 bar.
NOTE:
When the agitator is switched on, the power of the water pump is reduced.
Option:
High pressure water pump or compressor, available as an option, are controlled by the same control lever (Item
4, Fig. 7.24).
7.5.7
Vibrator
The control lever “Vibrator” (Item 8, Fig. 7.24) switches the
vibrator on.
Two operating modes are available:
MANUAL
=
Continuous operation
AUTO
=
The vibrator runs only when the pump
is switched on.
7.5.8
Horn/Reset
Irrespective of the operating mode setting “Desk” or
“Remote control” the horn can be sounded from any control
panel using the rocker switch “Horn/Reset/Lubrication”
(Item 6, Fig. 7.25).
If the Emergency Stop button has been pressed, provided all Emergency Stop buttons has been released, the
controls will be switched on again (reset).
6
7
8
14
Fig. 7.25 Control panel desk
