3 - 9
MAINTENANCE
JUNE 2021
32DSKF02.D
TITANIUM S-SERIES AND K-SERIES
PUBLIC USE SERVICE MANUAL
FIGURE 3-12: 2-INCH EXTENSION
FIGURE 3-13: PLACE REAR SPRING
g. Refer
to
Figure 3-13.
Use appropriate tool to use as leverage to pull back tine of bent rear spring and
place into baseplate tower.
h. Replace 2-Inch extension with existing pin.
i.
Reinstall screw and lock washer.
j.
Repeat removal and installation for opposite parallel arm.
8.
HYDRAULIC CYLINDER GLAND NUT AND PISTON REPLACEMENT
a. Lower lift to ground level.
NOTE
: Lift must be lowered as far as possible to avoid personal injury and oil spillage when hydraulic components
are dismantled.
b. Fully open manual release valve.
NOTE
: Important for allowing easy removal/insertion of ram into cylinder.
c. Install hydraulic breather tube if available.
NOTE
: The hydraulic breather tube may help in avoiding oil overflow from filler neck when reinstalling ram. An as-
sistant may be required to check oil level in filler neck as ram is reinserted, if breather tube is not available.
d. Loosen both hydraulic button head screws with 3/16” hex wrench to loosen pin.
e. Remove and retain cap screw with 5/32” hex wrench.
f.
Refer
to
Figure 3-14
. Drive rear pin out and retain. Use pin driver, pin is driven towards bushing side.
FIGURE 3-14: PLATFORM FOLDING BRACKET
g. Drive front pin out and retain.
NOTE
: Hydraulic cylinder may be left in baseplate “U” tower for this and proceeding operations.
i.
Refer
to
Figure 3-15
. Unscrew gland nut.
j.
Refer
to
Figure 3-15
. Pull shaft out.
k. Refer
to
Figure 3-15
. Remove old piston using appropriate tool. Heat piston thread if required to soften
the thread lock and remove piston.