30
The film
[6]
and the film tension regulator
[13]
(only for PV650 and PV250) is then
secured with the clamping plate
[2]
. Place the clamping plate in the middle of the
PowerVat bottom part
[1]
and use the screws
[8]
to attach the clamping plate to
the PowerVat bottom part, using the provided Torx wrench TX10.
Important:
When positioning the clamping plate, make sure that the film
is not being displaced.
The right above figure shows the recommended sequence for tightening the
screws (red numbers):
a)
Slightly tighten the screws crosswise (see picture for order)
b)
In analogy to a), tighten with the nominal tightening torque
Important:
When tightening the screws make sure that the film is not being
displaced. Improper tightening may result in an uneven film tension after
the film is stretched, which will decrease the printing quality (see section
[Step F] Assembling the Top Part
9
1
2
3
4
5
6
7
8
9
10
10
10
9
3
1
7
TX20
