15
Tighten the 8 screws on the bottom of the vat with the Torx wrench TX20. The
figure above shows the recommended sequence for tightening the screws (red
numbers):
a)
Slightly tighten the screws crosswise (see picture for order)
b)
In analogy to a), tighten with the nominal tightening torque
The film of the PowerVat now has the required tension and is ready for use.
Caution:
Do not start print jobs before all transport protections have been
removed and the 8 countersunk screws on the bottom of the PowerVat have
been properly tightened to guarantee the function and tightness of the vat.
If the transport protections are not removed before printing, material could
leak out of the vat and damage the printer.
TX20
1
2
3
4
5
6
7
8
