De-stoning machine EP 1000
Version: 136401000_M0014772F_EN400/50D
Datum: 15.01.2021
- 29 / 40 -
sight checks
The general state of the machine must be tested (condition of the weld and screw connections and of the electrical
connections, corrosion points, tears etc.) and the degree of soiling must be assessed.
The checks comprise the checking of the notices on the machine/line and the checking of the labelling of electrical
devices (these must be placed in an orderly manner and they must be legible). Loose clamps must be tightened at
once. Cables and clamps with signs of melting must be replaced at once.
Soiled devices must be cleaned. Defective parts must be replaced.
INFORMATION!
The carrying out of servicing work must be documented for warranty claims and the following data
given:
- Date
- machine/line area
- activity carried out
- name and signature of the person who performed the work
The documents are to be added to this Operating Manual and presented to the manufacturer on
request.
Spare parts
It is essential that spare parts should be stored on site to assure a high machine/line availability.
The spare parts recommended by the manufacturer are listed in the chapter "Spare parts documentation" of this
Operating Manual .
When ordering spare parts please follow the instructions in the chapter "Spare parts documentation - general".
Customer Service
Please apply to the machine/line supplier for questions on inspection, servicing and installation or for a servicing
visit (Customer Service data see the chapter "Spare parts documentation - general").
Replacement of parts that are still under warranty
When you replace parts and wish to have these exchanged by the manufacturer on the basis of the warranty, it is
a basic requirement that the replaced parts are made available to the maker.
A further requirement is the documentation of when, where and by whom the parts were replaced (see the chapter
"Servicing and repairs reporting").
If possible, the presumed cause of the defect should be given.
8.2 Lubricants Overview
Machine part
Aral
Castrol
Lubricant type
Bearings
standard commercial, foodstuff compatible grease
Grease
INFORMATION!
You can basically use any standard commercial, foodstuff compatible grease. Voran
recommends "
LF10 (H1
)".