42
Note: The maximum length for this parameter is 140 ASCII characters. The number of rules can
be adopted is limited by this length. Each rule must end with the “|” character. When there is
no match, the incoming GSM call is handled as if the Forward Number is blank.
5. Dial Plan
This Dial Plan is only valid for phone number entered in the Second Dial mode when a GSM call
is answered. The dial plan definition is the same as the one defined in the Dial Plan for the Call
Out section. However, the
Restricted Dial Plan
parameter is not available. To restrict certain
numbers, you can define the prefix and then modify it so that the numbers cannot be dialed out
successfully.
6. GSM Call Waiting
This parameter enables or disable the call waiting function during a GSM Calls.
1. Disable – When this is selected, the GSM Call Waiting function is disabled.
2. Mode 1 – When a call comes in during an active GSM call, the existing call is put on hold
immediately and the new call is answered. When the new call hangs up, the call on hold is
then resumed.
3. Mode 2 – When a new call comes in during an active GSM call, dial “32” to switch between
the two calls or dial “31” to hang up the active call.
4. Mode 3 – When a new call comes in during an active GSM call, the active is put on hold
immediate to answer the new call. The new call is then put on hold after 2 seconds and
the call on hold is then resumed.
7. Hunt Group Mode
Forward Mode
Backup Host Address
Hunt Group operation is discussed in details in Appendix D.
Please note that Hunt Group
Mode is a property of each GSM channel and is required to be set individually.
Host
- This enables the channel selected to be the Host of the Hunt Group operation.
All
clients registers and update the host on their channel status. The host then maintains a
list of clients status and selects an idle channel to receive the next incoming GSM call via
GSM call forwarding.
Please note that the device cannot have more than one Host
channel assigned.
Sharing of GSM channels between two Hunt Groups is supported. When all channels in
one group are in use, Call Forward will be set to the Host channel of the other group.
When a free channel is available again, Call Forward is then set to the free channel
instead. To enable this feature, the Backup Host Address must be set to the IP of the
GoIP which contains the Host channel of the other Hunt Group.
This parameter determines if the Host channel is going to be used for incoming call or not.
If the Forward Mode is set to Always, the Host channel will not be used for answering any
incoming calls. If it is set to Busy, then the Host channel will always to be used to answer
an incoming call whenever it is available.
Setting this parameter enables Hunt Group Sharing feature. This parameter must set the
IP of the device which contains the Host channel of the other Hunt Group.
Client
- This assigns the selected channel to be a client in Hunt Group mode.
Disable
Summary of Contents for GoIP
Page 26: ...26 ...