MAINTENANCE AND SERVICING
499
2. Depress the pin in the hinge's plastic cover
with a screwdriver or similar object.
3. Release the three snaps in the plastic cover
with a small screwdriver and remove the
cover.
4. Carefully pull out the section of the panel
that has been released.
Driver's side lamp housing shown
5. Remove the bulb holder by turning it coun-
terclockwise and pulling it out.
6. Remove the defective bulb by pressing it in
and turning it counterclockwise.
7. Insert a new bulb by pressing it in and turn-
ing it clockwise.
8. Insert the bulb holder by turning it clockwise.
9. Put the panel and plastic cover over the
hinge back in place in the reverse order.
When putting the plastic cover over the
hinges back in place:
•
The pin in the clip must be fully pressed
in before the clip is put back on the plas-
tic cover.
•
When the plastic cover is put back in
place, the pin must be pressed in until its
end is flush with the surface of the clip.
Related information
•
Summary of Contents for S 90
