VoloFone™ VF100
User Manual
Copyright © Vololink Pty Ltd 2006-08
V1.1 Jan 2008
Page 15 of 50
Voice Services
To use the VoloFone
™ VF100 as a wireless telephone connection:
Plug the phone lead into the RJ11 (
Phone
) port on the back of the VoloFone
™ VF100.
Lift the handset (you should hear a dial tone) and dial the number you wish to call. The Phone Light
on the front of the VoloFone™ VF100 will flash when the handset is off-hook.
If
Power-on PIN Lock
has been enabled
, the dial tone will be different (an intermittent tone instead
of the normal dial tone)
. Unlock the SIM
using the telephone keypad by entering the
PIN
followed by
#
then replace the handset.
VoloAdmin™
This section covers the administration of the VoloFone
™ VF100. There are many configurable features;
however, it is only necessary to configure one setting to make your VoloFone
™ VF100 work.
The setting that you need to configure is:
APN (Access Point Name)
If your VoloFone
™
VF100
was purchased as a packaged unit including a configured USIM, you do
not need to configure the APN.
It is recommended that even if you have a pre-configured unit, you complete the next step and record
the APN. This is to save time obtaining it from your service provider in the event it is lost due to a
configuration error or a reset some time in the future.
What is the
Access Point Name
?
– The
APN
is the name of your ISP’s wireless access point.
To configure the
APN
for your ISP, start by loading
VoloAdmin
™ as described above.
From the Navigation panel on the left select
Quick Setup
- the
Quick Setup
page appears:
Enter the name of your ISP’s
Access Point
in the editbox provided.
Click the
Apply
button.
The Test Button
On many of the configuration pages a
Test
button is present. Use the
Test
button to test the functionality
that you have just configured. When you are satisfied with the new configuration, click the
Apply
button.
Clicking the
Apply
button saves any changed settings permanently in non-volatile memory.
