Vollrath Stoelting Flavor Burst STL-80SS-DLX, Operator'S Manual

Page: 60 / 80

57
9. Place the Injector Assembly onto the
suspension bracket, so that the Gear Box
post slides into the bracket opening. Install
the Injector Head fully over the spout
adapter.
10. Push up on the Injector Assembly and lift
the locking collar up and over the adapter
tabs. Rotate the locking collar over the tabs
to secure.
11. Connect the Drive Motor cable to the Motor.
12. Ensure that the Gear Box of the Injector
Assembly is level horizontally and the Drive
Motor is straight vertically as it rests on the
bracket. Install and tighten the thumb nut to
secure the assembly’s position.
NOTE: THE SUSPENSION BRACKET
SHOULD BE POSITIONED ON THE GEAR
BOX DURING INITIAL SET-UP AND DOES
NOT NEED TO BE REMOVED DURING
OPENING OR CLOSING PROCEDURES
UNLESS IT REQUIRES A MORE THOROUGH
CLEANING. THE SUSPENSION BRACKET
SHOULD BE CLEANED AT LEAST EVERY 30
DAYS, EITHER WHEN CLEAN-IN-PLACE
PROCEDURE IS PERFORMED AND/OR
WHEN THE FREEZER DOOR IS REMOVED
FOR CLEANING.
13. Insert the syrup line manifold end fully into
the Injector Head syrup line opening.
Rotate it until motion stops to secure.