70
Keyset Mode
Keyset Mode
This feature allows you to determine the mode and baud rate of the
optional CTI Module connected to your phone.
This setting is stored in back-up memory in the case of a power outage
or system reset.
When telephone is set to AT command mode, the following AT
commands are supported:
Command
Mode
Description
Inactive
No CTI information is sent/received by the telephone.
ATD
Modem Dialing Command -- The telephone will recognize the
ATD and accept digits after the command.
ATH or
ATHX
(X= 0 or 1)
Modem On-Hook / Off-Hook Command -- ATH or ATH0 will
force the telephone to go to the on-hook state from its
current state. ATH1 will force the telephone to go to the off-
hook state from it’s current state.
CKTU
Command used with Wanderer (a cordless key telephone
unit). The baud rate is not used in this mode; no change is
necessary.
PC Phone
CTI information used with
Discovery Desktop
and
Discovery
PCPhone
software must be set to 4800 baud rate.
SPI
Service Provider Interface -- Command used with 1st Party
Call Control TAPI applications such as
Discovery Link
TAPI
For 3rd Party Call Control TAPI applications such as Discovery
Net Phone.
CKTU &
TAPI
For simultaneous use of CKTU and 3rd Party Call Control TAPI
Summary of Contents for XTS Station
Page 1: ...Vodavi Telephone Systems Station User Guide January 2005 Issue 2 0 P N 3152 00...
Page 10: ...viii Station User Guide 8 Button Executive Telephone 11 12 2 3 4 6 5 7 9 8 13 10 1...
Page 12: ...x Station User Guide 8 Button Enhanced Telephone Non Display 2 1 4 3 5 6 9 10 7 8...
Page 18: ......
