Programming System Functions Via Computer
1-29
Programming System Functions Via Computer
PC Accessibility
Cable Connection
-- The cable between the
MiniVoice
unit and the PC
must
be
a NULL MODEM arrangement with a 9-pin female connector on each end.
Lift the cover of the unit to access the programming port.
After connecting the cable to the PC, plug the other end into the
programming port on the
MiniVoice
unit.
Desktop or Laptop
-- Programming is accomplished through the use of a
laptop or standard PC desktop system. No special software is required. Any
communications package that supports ANSI terminal emulation will work.
The required port speed and protocol is 9600 BAUD, N-8-1.
If HyperTerminal is the communications package to be used, perform the
following steps before programming:
1. Select Start > Programs > Accessories > Communications >
HyperTerminal.
2. Setup a new connection using the following settings:
a.
Select COM1 or COM2, as required by your PC, then press OK
b. On the Comport Settings screen, set 9600, N 8 1, Flow Control to XON,
XOFF.
c.
Click OK.
d. Click on File > Properties, then select the Settings tab.
e. Select Auto Detect as the emulation.
f.
Click on the ASCII setup button and uncheck the “Wrap lines that
exceed terminal width” option.
g. Click OK, then click OK again.
3. The HyperTerminal connection is now configured properly for
programming the
MiniVoice
.
4. Exit HyperTerminal, then re-start the program.
5. After connected to the
MiniVoice
, press ESC to access the Main
Programming Menu.
