46
Network Camera User Manual
2. Check the corresponding version checkbox (Enable SNMPv1, Enable SNMPv2, Enable
SNMPv3) according to the version of the SNMP software that will be used.
3. Set the values for “Read SNMP Community”, “Write SNMP Community”, “Trap Address”,
“Trap Port” and so on. Please make sure the settings are the same as that of the SNMP software.
Note
: Please use the different version in accordance with the security level you required. The
higher the version is, the higher the level of the security is.
4.6.6
802.1x
If it is enabled, the camera’s data can be protected. When the camera is connected to the
network protected by the IEE802.1x, user authentication is needed.
47
Network Camera User Manual
To use this function, the camera should be connected to a switch supporting 802.1x protocol.
The switch can be reckoned as an authentication system to identify the device in a local
network. If the camera connected to the network interface of the switch has passed the
authentication of the switch, it can be accessed via the local network.
Protocol type and EAPOL version: Please use the default settings.
Username and password: The user name and password must be the same with the user name
and password applied for and registered in the authentication server.
4.6.7
RTSP
Go to Config
→
Network
→
RTSP.
Select “Enable” to enable the RTSP function.
Port
: Access port of the streaming media. The default number is 554.
RTSP Address
: The RTSP address (unicast) format that can be used to play the stream in a
media player.
Multicast Address
Mainstream
: The address format is
“rtsp://IP address: rtsp port/profile1?transportmode=mcast”.
Sub stream
: The address format is
“rtsp://IP address: rtsp port/profile2?transportmode=mcast”.
Third stream
: The address format is
Summary of Contents for Transcendent VTC-TNB8RFA3-2
Page 2: ......
