32
Network Camera User Manual
6. Make sure cameras can view objects for at least 2 seconds in the detected area for accurate
detection.
7. Adequate light and clear scenery are crucial for line crossing detection.
4.5.3
Intrusion
Intrusion
: Alarms will be triggered if the target intrudes into the pre-defined areas. This
function can be applicable to important supervision places, danger areas and prohibited areas,
like military administrative zones, high danger areas, no trespassing areas, etc.
Go to Config
→
Event
→
Intrusion interface as shown below.
1. Enable intrusion detection and select the snapshot type and the detection target.
Save Panoramic Picture
: If it is enabled, the detected panoramic pictures will be captured and
saved to the SD card when the targets intrude into the pre-defined areas.
Save Target Cutout
: If it is enabled, the detected target cutout pictures will be captured and
saved to the SD card when the targets intrude into the pre-defined areas.
Note
: To save snapshots to the local PC, please enable “Local Smart Snapshot Storage” in the
local config interface first. To save snapshots to the SD card, please install an SD card first.
Detection Target
:
Human:
Select it and then alarms will be triggered if someone intrudes into the pre-defined
area.
Motor Vehicle
: Select it and then alarms will be triggered if a vehicle with four or more wheels
(eg. a car, bus or truck) intrudes into the pre-defined area.
Motorcycle/Bicycle
: Select it and then alarms will be triggered if a vehicle with two wheels
(eg. a motorcycle or bicycle) intrudes into the pre-defined area.
All of the three types of objects can be selected simultaneously. Please select the detection
objects as needed. If no object/target is selected, alarms will not be triggered even if intrusion
33
Network Camera User Manual
detection is enabled.
2. Set the alarm holding time.
3. Set alarm trigger options. The setup steps are the same as motion detection. Please refer to
motion detection chapter for details.
4. Click the “Save” button to save the settings.
5. Set the alarm area of the intrusion detection. Click the “Area” tab to go to the interface as
shown below.
Set the alarm area number on the right side. Up to 4 alarm areas can be added.
Click the “Draw Area” button and then click around the area where you want to set as the
alarm area in the image on the left side (the alarm area should be a closed area). Click the
“Stop Draw” button to stop drawing. Click the “Clear” button to delete the alarm area. Click
the “Save” button to save the settings.
6. Set the schedule of the intrusion detection. The setup steps of the schedule are the same as
schedule recording setup (See
Schedule Recording
).
※ Configuration requirements of camera and surrounding area
1. Auto-focusing function should not be enabled for intrusion detection.
2. Avoid scenes with many trees or the scenes with various light changes (like many flashing
headlights). Avoid low lit areas.
3. Cameras should be mounted at a height of 8 feet or above.
4. Keep the mounting angle of the camera at about 45°.
5. The detected objects should not be less than 1% of the entire image and the largest sizes of
the detected objects should not be more than 1/8 of the entire image.
6. Make sure cameras can view objects for at least 2 seconds in the detected area for accurate
detection.
7. Adequate light and clear scenery are crucial to line crossing detection.
4.5.4
Region Entrance
Region Entrance
: Alarms will be triggered if the target enters the pre-defined areas.
Go to Config
→
Event
→
Region Entrance interface as shown below.
Summary of Contents for Transcendent VTC-TNB8RFA3-2
Page 2: ......
